Category: CLI

ESXi : Configuring network via CLI

by Axel September 28, 2017 No Comments

Hi folks ! After a recent fresh installation, I had to configure the host networking and confirm that the physical switchs of our ESXi hosts were connected to were properly configured. I could have done that by many ways (ESXi UI and Sphere client) but I though it could be nice to use some CLI […]

CLI

Nutanix : Create a three nodes cluster

by Axel September 28, 2017 No Comments

Hi, Just start working with Nutanix. Even if you can create a cluster directly from the foundation VM, it can be just cool to know I to create a cluster with a single command line. Here it is : From a CVM (you can open a SSH session, default credential are nutanix and nutanix/4u), run […]